Total Hydrocarbon Analyzer
Designed to continuously and accurately monitor Total hydrocarbon concentration during well logging and carbon bed detection.
About
The Measuresoft Total Hydrocarbon Analyzer (THA) is the candidate of choice whenever accurate, reliable total hydrocarbon analysis is required. The THA has a range from 10 ppm to 100% methane. The analyzer has a generous complement of analog and logic output capabilities.
The analyzer is based on a flame ionization detector (FID). During the combustion process, organic or hydrocarbon-based gases in the sample are ionized, then detected by the instrument and reported as a concentration in units.
The instrument is calibrated to ensure accuracy of +/- 5%, and is stable to within +/- 1% of full scale.
Applications
Designed to continuously monitor the total hydrocarbon content of non-condensing gases in a variety of applications, such as:
– Carbon bed breakthrough detection
– Well logging
Features
– Flame ionization detector
– 19″ rack mountable
– Calibrated output signal
– Analog output ranges from 10 ppm – 100% full scale
– Automatic FID ignition, with automatic shut-off of sample, fuel and combustion air
– Data Output: 4-20Amp Analog, 0-10V Analog and USB
– Digital display
Analytical Specs
– Detector – Flame ionization detector (FID)
– Ranges – Full-scale 10 ppm – 100% (Methane)
– Repeatability – The instrument is calibrated to ensure accuracy of +/- 5% of signal
– Drift – ±3% of Full-Scale over 24 hours
– Response Time – < 5 seconds to 90% of final reading
– Calibration – Manual calibration
– Support Gas – Hydrogen 35 cc/min, Air 175 cc/min (typical). Hydrocarbon content must be less than 1 ppm
Physical Specs
– Nominal Dimensions – 19″ W x 21″ D x 5.5″ H
– Weight – < 20 lb
– Configuration – Bench-top or rack-mounted 19″ (48.3cm) panel
– Connections – 1/4″ tube fitting connectors
– Operating Temperature – 32 to 104°F (0 to 40°C)
– Operating Humidity – 0 – 95% (non-condensing)
Electrical Specs
– Power – 120-240 VAC, 50/60Hz, 3A
– Display – 6.5″ x 2″ Digital display
– Analog Outputs – 4-20mA isolated, 0-10V Analog and USB